|Product Name:||HHO Carbon Cleaning Machine||Usage:||Carbon Removal|
|Vlotage:||AC220V||Dimension - L*w*h (mm):||600*600*1100mm|
hho carbon cleaner,
car decarbonization machine
HHO Carbon Cleaning Machine Engine Carbon Removal Products Fuel Saver
1. Using pure water and electrolytes to produce Hydrogen and Oxygen.
2. The gas enter the engine system through pipelines.
3. Cleaning carbon only needs 20 minutes.
4. Through removing the engine carbon deposit to decrease the fuel consumption.
5. Finally the carbon becomes CO2 and H2O draining the exhaust pipe.
6. No need to dismantle engines parts
7. No harm to engine, human and environment
8. Much cost saving than the other machine.
|AC Voltage Requirement (V)||220~240V,single phase|
|AC Current (A)||<15|
|Max. Gas Output(L/h)||1500|
|Max. Working Pressure (Mpa)||0.02|
|Max. Water Consumption (L/h)||0.7|
|Dimensions - L*W*H (mm)||600*650*1250|
Effects of carbon cleaning:
1. Reduce oil consumption
2. Reduce engine noise
3. Save car repairing cost
4. Prolong engine life
5. Increase 20% of engine power
6. Decrease 70% of air pollution
Causes of carbon cleaning failure
|No.||Fault phenomenon||Cause Analysis||Method of exclusion|
|1||The machine does not work when the start button is pressed||Missing phase, carbon removal control board failure or air switch damage or emergency stop button has been pressed||
1)1) Check the power supply
2)2) Replace the faulty device
3)Detect emergency stop button
|2||When the equipment is working, the gas production is too low to meet the requirements for use.||The electrolyte concentration is too low, the electrolytic cell is too dirty, and the electrolyte is not clean.||Cleaning the electrolytic cell, descaling, replacing the electrolyte|
|3||Over pressure alarm||Equipment line blockage||Check equipment piping|
|4||Normal air pressure, low air output||Equipment piping leaks||Check equipment piping to find leaks and recover|
|5||Work indicator does not light after booting||The power module or power cable is not connected properly.||Check the line, replace the power module, and replace the power cord|